ASI 0119 - American Specialties, Inc. - Hand Dryer Semi Recessed Kit, White
The ASI 0119 by American Specialties is a Semi-Recessing mounting box shall reduce projection of TurboDri dryer 0197 to less than 4 inches from wall face for ADAAG and CalDAG Barrier Free Compliance. Cover shall be fabricated of 20 gauge cold rolled steel with white porcelain enamel. Wall box shall be fabricated of 20 gauge type 304 stainless steel alloy 18-8 with matt finish. Box shall have eight 7/32 inch diameter mounting holes provided in sides on adjustable tabs (2 per vertical side) that eliminate requirement for shim fitting for installation purposes. Three 7/8 inch diameter holes shall be provided on the bottom wall and one shall be provided on each bottom sidewall to facilitate power entry location. Mounting holes shall be provided in the box rear pan to match the mounting hole pattern of the dryer unit (mounting hardware is supplied with dryer units) and holes shall have captive 1/4-20 threaded fasteners to receive dryer mounting hardware. Full-face cover shall be formed from one piece with no miters, welding or open seams on face and shall have 1/4 inch square returns to wall. Cover shall be retained after closure with four security pin-Torx 1/4-20 flat head screws flush with panel face and shall have black rubber vibration isolation gasket. Structural assembly of all components shall be of welded construction. Cabinet shall have no exposed spot-welded seams. Dryer purchased separately. Manufacturer Model #:10-0119.
Install mounting box in wall recess using Number 10 fasteners appropriate for the wall conditions (supplied by installer) through concealed mounting holes provided.
Electrical service is made by qualified electrician through knockouts provided with use of appropriate connector (supplied by installer) to meet codes having jurisdiction and left rough with a 14 inch pull.
Rough Wall Opening: 10-3/4" Wide x 16-3/8" High x 3-3/4" Minimum Depth
Operation
Unit remains integral to wall framing after installation.
There are no moving or adjustable parts requiring owner access or service.
Air intake hole pattern in cover should be kept clean on regular maintenance schedule.
